1. Scope

1.1 This specification covers electric-fusion (arc)-welded straight seam or spiral seam steel pipe NPS 16 and over in diameter (inside or outside as specified by purchaser), with wall thicknesses up to 3/4 in.(19.0mm), inclusive. Pipe having other diamensions may be furnished provided. such pipe complies with all other requirements of this specification.

Note 1 - Acceptability for many services may be controlled by codes or standards such as those published by the American National Standards Institute and American Society of Mechanical Engineers.

Note 2 - For testing methods not specifically covered in this specification, reference can be made to Test Methods and Definitions A 370,

with particular reference to Annex A2 on Steel Tubular Products.

Note 3 - A comprehensive listing of standardized pipe dimensions is contained in ANSI B 36.10

1.2 The values stated in inch-pound units are to be regarded as the standard.

Note 4 - The dimensionless designator NPS(nominal pipe size)has been substituted in this standard for such traditional terms as "nominal diameter", "size", and "nominal size".

1.3 The following precautionary caveat pertains specifically to Section 5 of this specification. This standard does not purport to address all of the safety problems, if any, asssociated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Material Comparison Tables (ASTM ℃KS, JIS, DIN, BS, NBN, NF, UNI)